TazzI wrote:ferret82 wrote:hi,
im not sure if this is the right place to post but i am after some help with VY/VZ cluster programming.
i have managed to work out how to chnage the startup logos and shut-down text and even changing the RPM of when the shift light comes on using the following code.
only issue i have is if i swap the startup logo away from HSV the shift light stops working
does anyone here know the code i need to make the shift light work for all logos especially the holden one?
Hi Ferret,
To get the redline change working for all logos is alot harder then a simple change of a byte using that frame that I posted a while back. Have to dump the eeprom over comms to obtain the section with the redline info, then write back that section with the updated values.
Although this requires a seed/key operation to unlock the cluster and obtain specific locations within it.
Taz.
Hi Taz,
i had a feeling that getting the redline change to work for all logos was going to be a bigger job.
i believe i have cracked how to unlock the cluster by sending the seed / key, any chnacde you could point me in the area where the redline info is and what i would need to change it to? big ask i know, but so far you seam to be the only person i have found that knows a lot about these clusters, and redline working on a holden logo is my ultimate goal.