Welcome Anonymous !

Everything you need to modify your ride
 

ECUs, ODBII DTCs and PIDs

Clock spring reads ok with meter but u/s

Discuss Diagnostic Trouble Codes and Parameter IDs for the Holden VY and VZ Commodores, Pontiac GTO, Vauxhall Monaro, and Chevrolet Lumina Models

Postby nikolatesla » Sat May 25, 2019 6:08 pm

Hi guys new guy here but a techie by trade.
I have recently dealt with a clock spring which reads 2 ohms with an analouge meter but is faulty acording to the software by Tazzie .

I pulled the clock spring apart and eventually found a place that would cause high resistance when bent .

moral of the story...the computer does a good job of testing this circuit ..I nhate to admit that ..I hope this helps somebody else !
nikolatesla
Newbie Modder
 
Posts: 2
Joined: Sat May 25, 2019 5:30 pm
Has thanked: 0 time
Been thanked: 0 time

Return to ECUs, ODBII DTCs and PIDs

cron
  • View new posts
  • View unanswered posts
  • Who is online
  • In total there are 2 users online :: 0 registered, 0 hidden and 2 guests (based on users active over the past 5 minutes)
  • Most users ever online was 1184 on Wed May 15, 2024 10:08 am
  • Users browsing this forum: No registered users and 2 guests